The quality of the application depends largely on how the plastics are prepared.

Before applying your graphics kit, the plastics must be perfectly clean and degreased. We recommend using a good-quality brake cleaner.

Do not use household products, multi-purpose cleaners or degreasers that leave a residue, as they can compromise the adhesion of the glue.

Once the kit is installed, each piece must be heated (with a heat gun or a hair dryer), then firm pressure must be applied over the whole sticker, paying particular attention to the edges and curved areas.

This step is essential: it activates the glue and ensures long-lasting adhesion to the plastics.

We also recommend leaving the bike to rest for 24 hours after application, at room temperature, before riding or washing it.

To protect your graphics kit, we recommend storing your bike in a dry place at a moderate temperature. Avoid large temperature swings and prolonged exposure to cold or excessive heat, which can alter the properties of the adhesive.

Our graphics kits are designed to withstand UV and bad weather. However, whenever possible, park under cover to keep the colours bright and your kit looking good for longer.

To clean your bike, wash it by hand with:

• a non-abrasive sponge
• lukewarm water
• a mild soap

If you use a pressure washer, never aim the jet directly at the edges of the stickers or from very close range

• Always clean your bike when it is cold.
• Avoid solvents and any harsh chemical.
• If an edge lifts slightly, heat the area and then press firmly.

Our graphics kits are made with professional-grade materials. Their durability nevertheless depends on following the preparation, application and care instructions.

Any adhesion defect caused by poor preparation of the plastics or by not following the application and care recommendations cannot be covered.