Care guide

Keep your kit like day one.

Our graphics kits are made from professional materials, designed to withstand UV, bad weather and heavy use. A few simple precautions guarantee optimal grip and keep them looking good for as long as possible.

Keep your kit like day one.

From fitting to washing

The 4 steps of care

How well your kit holds starts before fitting and continues throughout its life.

Before fitting: essential preparation

Before fitting: essential preparation

The quality of the fitting depends largely on how well the plastics are prepared.

Before applying your graphics kit, the plastics must be perfectly clean and degreased. We recommend a good quality brake cleaner.

Do not use household products, all-purpose cleaners or degreasers that leave a residue: they can compromise the grip of the glue.

After fitting

After fitting

Once the kit is fitted, every piece must be heated (with a heat gun or a hairdryer), then firm pressure must be applied over the whole sticker, especially on the edges and curved areas.

This step is essential: it activates the glue and ensures lasting grip on the plastics.

We also recommend leaving the bike to rest for 24 hours after fitting, at room temperature, before riding or washing it.

Storing the bike

Storing the bike

To protect your graphics kit, keep your bike in a dry place at a moderate temperature. Avoid big temperature swings and long exposure to cold or excessive heat, which can alter the properties of the adhesive.

Our graphics kits are designed to withstand UV and bad weather. When you can, still choose a sheltered spot to keep the colours bright and your kit looking good for longer.

Cleaning

Cleaning

To clean your bike, choose hand washing with:

  • a non-abrasive sponge
  • lukewarm water
  • a mild soap

If you use a pressure washer, never aim the jet directly at the edges of the stickers or from very close range.

Tips

Good habits

Do

  • Always clean your bike when it is cold.
  • If an edge lifts slightly, gently warm the area, then apply firm pressure for a few seconds.
  • After a ride in mud or sand, clean your bike as soon as possible to keep your graphics kit looking good.

Avoid

  • Solvents, acetone, petrol or any harsh chemical on the stickers.
  • A pressure washer jet aimed at the edges of the stickers or from very close range.
  • Household products, all-purpose cleaners and degreasers that leave a residue.

Warranty

Follow the instructions and your kit lasts for years

Our graphics kits are made from professional-quality materials, and every order is checked before shipping.

However, how well a kit holds depends on how the plastics are prepared, the fitting conditions and the care it gets. Adhesion defects, peeling or damage resulting from insufficient preparation of the plastics, fitting that does not follow the recommendations, unsuitable care or extreme conditions of use or storage cannot be covered by the warranty.

By following this advice, your graphics kit will keep its grip, its colours and its look for many years.

Follow the instructions and your kit lasts for years

In doubt?

An edge coming up?

Message us on WhatsApp, we reply within 24 to 48 hours. You can also read the fitting guide again.